Frequently Asked Questions - Astron Solar Motion Light

The Astron has been discontinued. However the Slimsafe light that is an upgrade can be fitter onto a fence panel as long as the measurments match

It is white in colour, we do have a 30 days policy for unwanted returns if unused and installed.

I am afraid not. The pir sensor cannot be turned off on this light. 

You do not need a screw. Once positioned it will stay on the specific angle selected as it fits between the two ends of the light and secures there.

https://www.thesolarcentre.co.uk/products/Warwick_Solar_Wall_Light-990-56.html

The Warwick light will illuminate and when someone is approaching it will activate at full brightness. 

The detection is 80 to 100 degrees. 

There is a bracket on the back which you screw onto the wall. 

Dimensions

Top 12.5cm x 16.2cm Back 16.2cm x 7cm

The batteries are rechargable, so they rely on the solar panel to charge them up. 

Please note the PIR motion sensor (the white “bubble” on the front of the light unit) needs to be pointing to where you want any motion detected to operate the light.

1.Leave the light to charge for 3 - 5 days

2. Push and hold the light switch button to the right of the white PIR bubble after dark for approximately three seconds. The AstronSolar Motion Light will activate immediately in power saving mode and turn off again after motion has ceased.

3. Push the light switch button again briefly to activate full brightness mode

.4. To turn the light off permanently push and hold the switch button for 3 seconds.

The light will go out once motion has ceased.There is no background light. 

We do not have any drawnings however in the instructions that come with the light state. The Astron Solar Motion Light should be installed onto a flat vertical surface. Measure, mark and drill the screw holes. Drill the marked holes, insert wall plugs and screw the Astron Solar Motion Light into position.

Yes it can pick up motion from the side 

Hi, these are not adjustable on this model, this is only adjustable on our EVO SMD Range

Provided that the light is in a good sunny position to re-charge and not under any eaves/roofing (as the panel is on top) then it will be fine. As it a motion activated it will last longer in the winter months as it is not on all the time. 

We would not recommend this for a North facing wall. 

The panel is on top of the light. 

This light has a fixed up to 30seconds before switching off however if it detects motion it will stay on.

Top 12.5cm x 16.2cm Back 16.2cm x 7cm

That is correct there is a fixing plate you can screw in. 

The PIR sensor is fixed on this light, it will pick up movement around 120 degrees 

This is just motion activated 

no unfortunately 

There is an on/off switch near the sensor. 

I am afraid that the angle of the sensor and the run time, once the PIR sensor triggers, cannot be adjusted on this unit.

There is an on/off switch but not an overide, this light will only work as a motion detection light. 

Ther is bracket on the back of the light, you unscrew two screw and then pop the screws through and drill them to in the wall.

The batteries cannot be changed sadly, however these are a long life battery and should last up to 4 years. 

Top 12.5cm x 16.2cm Back 16.2cm x 7cm