800 lumens
Hello,
It stays luminated for 20 seconds.
I would possibly recommend the EVO SMD Remote control, you will have more control of when it goes on off. It is our brightest floodlight.
Hi Paul,
These are 1.25 kg so may be too heavy for guttering
Hello.
I am afraid we do not stock extension cables for this particular light.
HI John, It would be IP54
Hi Kelsie, the panel can be extended a little bit hopefully into a south facing position for you. ~The cable is 250 cm long
Hi Derek,
BLUE - Light is set to remain at low brightness until motion is detected which activates high brightness for up to 20 seconds
RED - Light will only activate when motion is detected [This is the best mode for winter]
BLUE + RED - Light is set to remain ON all night
We expect our products to last for a minimum of one/ two years, but this varies depending on the location, installation and the customer.
The whole unit can be attached to the wall however the panel cannot be detached from the light to be positined elsewhere. You would need a light that comes with a remote panel. Such as the Shield, Evo, etc. if you need any assistance in finding the right light for you please give us a call or email us
Hi Patrick, thank you for your message. there are three modes you can have this light on.
1.Low brightness all night till motion is detected it will come on full brightness for 20 seconds.
2 .Light will only activate when motion is detected [This is the best mode for winter]
3. Light is set to remain ON all night
This light has an IP rating of IP65.
No sorry.
No, the panel is attached, all the fittings you need to mount the light are included
No sorry, we are updating our site all the time. Once purchased you get full instructions and all the fixtures needed to fit the light.
This unit holds a lithium battery.
we expect our lights to last min 2 years
There is a wall mounting bracket provided.
The bracket for the panel would be supplied. The panel should be South facing.
There is an option to have the panel integrated or away from the light. It will come on when there is motion, however, there is an option to have a dimmer light all the time and then brighter when motion is detected.
The light can be turned on/off, the button can be found on the light.
It is approximately 2meters of cable.
We recommend testing the unit on the level of the wall that you want to install making sure that it covers your needs.
The PIR sensor will have a range of up 10m.
The light will come on automatically when it gets dark.
The PIR sensor cannot be adjusted. However, you can adjust the Led's and the solar panel.
I am afraid not, the batteries cannot be replaced.
The solar panel can be placed on top of the light or can be connected via a cable and be positioned separately. It is approximately 2meters of cable.
The batteries are pre-installed inside the light head.
It can also be installed away from the light.
The size of the bracket is: 110mm x 100mm
The batteries are pre-installed.
The light comes with a wall mounting bracket.
The light has 3 modes:
1. Light is set to remain at low brightness until motion is detected which activates high brightness for up to 20 seconds
2. Light will activate only when it detects motion
3. Light is set to remain ON all night.
It is 180 degrees.
The motion sensor will detect up to 10m with a 120-degree detection angle.
PIR is the motion detector. So it will only go on/off with motion.
No sorry, this isn't possible.
The PIR is fixed and cannot be moved.
No the light doesn't move as the lights cover a large area.
There is a cable between the panel and the light so it can be installed in a different location if that is essential.
No it cannot be adjusted
The light will stay on for 20 seconds once motion has been detected.
There is no cable, the panel is on top.