The panel needs to be in the dark for the lights to come on as that is where the sensor is. The only way to make this come on in the day would be to cover the panel tricking it into thinking it is dusk, however the panel will not be charging the batteries when covered, so we do not really recommend this.
These are a cold/bright white colour and cannot be cut to size.
Hello.
There is 3M of cable between between the strip and panel.
Hello,
The strip is 10m long.
Hello,
The Madison lights do have an ON/OFF switch on the back of the panel.
Hello, these are weatherproof, but we do not advise these to be submerged in water. There is no need to cover the panel at all. If we do get adverse weather just clear it from the panel, such as snow or heavy frost.
Hi Russell, The strip light is 10 meters long
Hi Simran, The panel can be attached to a flat piece of wood
Hi Ben, These lights are waather proof but when you ask about waterproofing we dont advise to submerge the lights under water
Hi Jilly, the lights do have a blue tabpe that has an adhesive under it and it should allow the light to stick to wood just be careful that the the whole adhesive does not come off when taking off the blue strip
Hi, the width of the strip is 18mm.
The Madison solar panels come with 3m of cable between the solar panel and the lights
Hi, the cable is 3m.
Hello,
Yes it should do.
3m
Hi,
the adhesive may not be as sticky depending on the surface and the state of the adhesive strip itself.
Hello,
Unfortunately, we do not recommend trimming the striplight to become 2 units of 5m, as this will stop the light from functioning.
Hi Paul, we would not advise cutting the light as it may damage the circuit and the light will not work. This will also void your warranty
Hello,
Thank you for your question.
These lights are a cool white and they should stick to wood with the adhesive that comes with it.
18mm
18mm
We have an alternative in the Edge range:
https://www.thesolarcentre.co.uk/products/Edge_5M_Solar_Strip_Light_Warm_White_240_LEDS-1233-77.html
Hi Ron,
The adhesive should stick to brick/concrete.
Hi Andrew,
It's a 10m long outdoor solar powered strip light, it comes as one so there is no option to attach.
Hi Amer,
You will find the push botton on the underside of your solar panel.
First press: The lights will come on after dark in full brightness mode.
Second press: The lights will come on at dusk in the first powersaving mode (brightness reduced slightly, but will work for longer)
Third press: The lights will come on at dusk in the second powersaving mode (brightness will reduce by half, but will work for even longer)
Fourth press: The lights will turn off and will not turn on automatically, but they will still charge.
Hi Luke,
Unfortunately we don't offer an extension cable for the Madison Solar Strip Lights, apologies.
Hi Yvonne,
It's a 10m long outdoor solar powered strip light. Hope this helps.
Hi Ian, They have a on and off button located in the panel
Hi Ron,
We would not advise to cut these they are pretty felxible to bend in corners. Cutting these would void the warranty
Hi Dave, Thank you for your message, wouldnt advise cutting these as it may stop them working and the warranty would no longer be valid
Hi Jack, Thank you for your message. The Madison strip light are cool white
Unfortuntately they cannot be trimmed down.
Unfortunately not as the panel has only enough power for one set.
Hi Andy, the Madison strip lights are 10m long
Madison's 3W solar panel is 6 times more powerful than a standard decorative lighting solar panel so it is advised to use the panel it comes with.
Hi Rebecca, you can switch the lights off and on by the switch located on the back of the solar panel.
Unfortunately this isn't possible without soldering where the cut is made between the two positive terminals.
Hi Stuart, Thank you for your message, our Madison Strips are about 40 lumnes in brightness, I would say they are similar to Christmas decorative lights. All our products have one year warranty
The Madison solar panels come with 3m of cable between the solar panel and the lights
Generally, it's pretty hard to get anything to stick to house bricks. It really depends on the effect you are looking for but maybe you could add a tiny wooden shelf and add the light underneath or you could hand the lights on hooks?
these are a cool white. I would try and test a small section before installing as we have not tried it on smooth granite.
It comes with an 18650 lithium battery.
There are decorative lights.
The pins would damage the tube, you can use small hooks or something similar.
There are 10m of tube lights.
There are 10m. You cannot adjust the length.
It does come with a solar panel.
It is 10m of tube lights.
You cannot cut or adjust the length.