The on/off button is the one you are describing. As it has just arrived, please allow the light to charge for 3-5 days in as much direct sunlight and then do try using the button again. Please can I just make sure when you are testing the light in the dark, so please cover the panel with a towel and try it that way. If you are having any issues, please do get in touch with us and email [email protected]
Hello,
Please see tbelow from the instructions the Three modes. So to not have it on all the time, you might just want to use mode two.
How to use:
Mode 1: Light is set to remain at low brightness until motion is detected which activates high brightness for up to 28 seconds.
Mode 2: Light will only activate when motion is detected for up to 28 seconds [This is the best mode for winter]
Mode 3: Light is set to remain OFF.
Hi Tim, would not be able to secure these light against a fence unless you have solid floor by the fence
Hi Edward,
no, the lights are not linked, however they do work off a dusk-til-dawn sensor meaning they will switch on and switch off around the same time, depending on light conditions during dusk/dawn.
Unfortunately we would not recommend leaving your lights in a heavily shaded area as this will impact their ability to recharge and function properly.
Hi John,
Thank you for bringing this to our attention. The dimensions are:
Height: 40 cm
Width: 13 cm
Depth 13 cm
You will have to screw the base on a hard surface.