600 lumens
5000K
The Motion Sensor setting switches the light to full power for 35 seconds.
I am afraid that lights cannot be paired to one remote.
Please see the different lighting modes. There will always been a low level of light.
Lighting Mode
M1:100% brightness for 5 hours+20% brightness till dawn
M2: 60% brightness till dawn
M3:20% brightness + PIR till dawnT:100% brightness for 2 hours + back to previous mode. [This modeis only activated by pressing the ‘T’ button on the remote control].
I am a little confused by your question, but please see below and hopefully this will help.
Mode 1: 100% brightness for 5 hours then 20% brightness until dawn
Mode 2: 60% brightness until dawn
Mode 3: 20% brightness until dawn with full brightness activated
T: 100% brightness for 2 hours, then reverts to the previous mode you had the light on.
Hello.
The battery is not replaceable
The Shawford has an 8m range
Hello,
The light should not be exposed to extreme temperatures (below -25°C or above 50°C), or submerged in water. It is waterproof but not water resistant. This light has been tested as IP65.
Its 600 Lumens
On the remote, you will have
On/Off button,
Mode 1: 100% brightness for 5 hours then 20% brightness until dawn
Mode 2: 60% brightness until dawn
Mode 3: 20% brightness until dawn with full brightness activated
T: 100% brightness for 2 hours, then reverts to the previous mode you had the light on.